Plasma Cutting Explained: What To Consider Before You Invest

Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at Tec Products Thirsk are set up to help with.

Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.

Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.

Budget for a first machine is rarely just the welder itself. A gas cylinder and regulator for MIG or TIG, a decent auto-darkening helmet, gloves and basic workshop ventilation all add to the real cost of getting started, and skimping on the supporting equipment tends to cost more in frustration than it saves in cash. It's worth pricing the whole set-up before settling on a machine at the top of the budget.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.