Plasma Cutting Explained: What To Consider Before You Invest

Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder's rated speed is a basic habit worth building into every new batch you open.

The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.

Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at visit the website are set up to help with.

A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.

If you're not sure which supply a particular machine needs or whether your workshop can support it, it's a sensible question to put to a supplier before ordering, and the team at visit the website can talk through the options against your existing set-up.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.