Our Own TP Weld Tables Range Is Designed And Manufactured In-house In Yorkshire, Cut On A Fibre Laser For Tight Tolerances, Which Is The Kind Of Detail Worth Asking About Wherever You're Sourcing A Table, And You Can See The Full Range Via welding Tables.

A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.

Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Our own TP Weld Tables range is designed and manufactured in-house in Yorkshire, cut on a fibre laser for tight tolerances, which is the kind of detail worth asking about wherever you're sourcing a table, and you can see the full range via welding tables.

TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.

Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.